You Will Need:
  • JetWear™ Cold-Peel iron-on transfer paper
  • Cotton or cotton/poly blend garment (white or light-colored)
  • Large pillowcase
  • Hand iron
  • Smooth, hard, heat-resistant surface
1. Printing Your Transfer
  • Insert a single sheet of transfer paper into the printer with the printable surface loaded correctly for your printer. (See your printer manual if necessary.)
  • Mirror or flip image prior to printing.
  • Trim away any unprinted paper around your image.
2. Preparing to Hand-Iron
  • Preheat iron for 5 minutes on hottest setting. Do not use steam setting!
  • For proper pressure, use an ironing surface that is waist- level or lower. Do not use ironing board, glass, concrete, granite, or any soft or heat-sensitive surface!
  • Fold the pillowcase in half and place it on the ironing surface with the open end hanging over the edge. Iron pillowcase to remove any wrinkles.
  • Place garment over the center of the pillowcase. Iron the garment to remove any wrinkles.
  • Center the transfer paper--image side down--on garment.
3. Hand-Ironing Times
  • For a full-page transfer, iron for 3 minutes in pattern illustrated in next step.
  • For a half-page transfer, move iron in continuous circles for 90 seconds.
  • For a quarter-page transfer, move iron in continuous circles for 45 seconds, or for 30 seconds if smaller than a quarter-page.
4. Hand-Ironing Your Transfer
  • Step A: Holding the iron as pictured, firmly slide across transfer paper from right to left, making 4 equal passes of 20 seconds each. Be sure to pass over all edges.
  • Step B: Holding the iron as pictured, firmly slide the iron from bottom to top, making 5 passes of 20 seconds each. Be sure to pass over all edges.
5. Removing Paper From Back
  • Allow garment to cool for at least 2 minutes.
  • When cold to the touch, peel away the transfer paper using steady pressure, starting from one corner.
  • If paper tears, try a different corner.
6. Washing Instructions
  • Wash garment seperately (first time only). Turn inside out.
  • Machine wash cold with color-safe detergent. No bleach.
  • Remove promptly from washer to prevent bleeding. If bleeding occurs, rewash immediately.
  • Tumble dry with low heat. Add towels to facilitate drying.
Using A Heat Press (Commercial Use)
  • Place garment on press pad. Center transfer on
    garment (face down).
  • Press at 375°F (190°C) with high pressure for 15 seconds.
  • Peel immediately for matte finish with soft hand.
  • Peel when cool for gloss finish and slightly heavier hand.

Important Notes:

Printer & Copier Inks
CMW, Inc. offers papers for inkjet, laser, thermal wax and sublimation printers and copiers. In all cases, our papers are optimized to perform with OEM inks and toners. CMW does not warrant use of aftermarket inks and toners, and cannot guarantee satisfactory results. We recommend that you test any non-OEM inks or toners prior to use. Please visit our knowledge base at www.cmwi.com for more information.

Product Quality Assurance
CMW, Inc. conducts exhaustive testing on all its products, using
many types of substrates, printers, copiers, heat presses, irons,
and laundry detergents. However, it is impossible to duplicate
all printing and transfer processes, so we recommend testing
your chosen paper to determine its suitability to your needs
and equipment. Please visit our knowledge base at
www.cmwi.com for more information.
 
CMW, Inc. ● 400 Third Ave ● Suit 214 ● Kingston,PA 18704 ● Phone: 1.866.783.4700 ● Fax: 570.714.8633 ● info@cmwi.com